Cisco interface show commands

    show module command
    show module command cisco
    show module commands powershell
    cisco show sfp module command
  • Show module command
    • Show run commands

    Show running command cisco!

    To display module status and information, use the show module command. For supervisor engines, the show module command displays the supervisor engine number but appends the uplink daughter card's module type and information.

    If you do not specify a module number, all modules are shown.

    The MAC addresses for the supervisor engine are displayed in three lines of output.

    Cisco show users command

  • Cisco show users command
  • Show hosts command cisco
  • Show running command cisco
  • Cisco command to show device information
  • Cisco command to show circuit id

    • The first line lists the two MAC addresses for inband ports, the second line lists the two MAC addresses for the two gigabit-uplink ports, and the third line lists the allocated 0x3ff MAC address for the chassis backplane.

    If you place the MSFC on a supervisor engine installed in slot 1, then the MSFC is recognized as module 15.

    If you install the supervisor engine in slot 2, the MSFC is recognized as module 16.

    The slot field in the show module command display is required because submodules, such as the MSM, reside in the same slot as the supervisor engine module, but are treated as a separate module.

    The MSM is referenced by the module number in all other CLI commands and is treated like any other module.

      get-command module
      show modules